MIL-M-27274E(USAF)
c. Size or sizes required (see 1.2).
d. When first article is required (see 3.1, 4.4.1 and 6.4).
e. Levels of preservation, packaging, and packing required (see section 5). f. When palletization is required (see 5.4).
6.3 Consideration of data requirements. The following data requirements should be considered when this specification is applied on a contract. The applicable Data Item Descriptions (DIDs) should be reviewed in conjunction with the specific acquisition to ensure that only essential data are requested/provided and that the DIDs are tailored to reflect the requirements of the specific acquisition. To ensure correct contractual application of the data requirements, a Contract Data Requirements List (DD Form 1423) must be prepared to obtain the data, except where DOD FAR Supplement 27.475-1 exempts the requirement for a DD Form 1423.
Reference Paragraph DID Number DID Title
4.4.2 DI-T-2072 Inspection Test Reports
The above DIDs were those cleared as of the date of this inspection. The current issue of DOD 5010.12- L, Acquisition Management Systems and Data Requirements Control List (AMSDL), must be researched to ensure that only current, cleared DID's are cited on the DD Form 1423.
6.4 First article. When first article inspection is required, the contracting officer should provide specific guidance to offerors whether the item(s) should be a preproduction sample, a first article sample, a first production item, a sample selected from the first production items, a standard production item from the contractor's current inventory (see 3.1), and the number of items to be tested as specified in 4.4.1. The contracting officer should also include specified instructions in acquisition documents regarding arrangements for examinations, approval of first article test results, and disposition of first articles. Invitations for bids should provide that the Government reserves the right to waive the requirement for samples for first article inspection to those bidders offering a product which has been previously acquired
or tested by the Government, and that bidders offering such products who wish to rely on such production or test, must furnish evidence with the bid that prior Government approval is presently appropriate for the pending contract. Bidders should not submit alternate bids unless specifically requested to do so in the solicitation.
6.5 Part or Identifying Number (PIN). The PIN system is as follows:
Example of PIN: M27274-M20
Size if applicable (see table I) Item (see table I)
Specification number
An item defined by inch-pound units
11
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business