MIL-M-19417D
Water Absorption of Plastics
ASTM D 570
ASTM D 635
Rate of Burning and/or Extent and Time
of Burning of Self-Supporting Plastics
in a Horizontal Position
ASTM D 638
Tensile Properties of Plastics
ASTM D 648
Deflection Temperature of Plastics
Under Flexural Load
ASTM D 695
Compressive Properties of Rigid Plastics
ASTM D 790
Flexural Properties of Unreinforced and
Reinforced Plastics and Electrical
Insulating Materials
ASTM D 1003
Haze and Luminous Transmittance of
Transparent Plastics
ASTM D 1044
Resistance of Transparent Plastics
to Surface Abrasion
ASTM D 1149
Rubber Deterioration - Surface Ozone
Cracking in a chamber (Flat specimens)
ASTM E 831
Linear Thermal Expansion of Solid
Materials By Thermomechanical Analysis
ASTM F 791
Stress Crazing of Transparent Plastics
(Application for copies should be addressed to the American Society for
Testing and Materials, 1916 Race Street, Philadelphia, PA 19103.)
(Non-Government standards and other publications are normally available from
organizations that prepare and distribute the documents. These documents also
may be available in or through libraries or other informational services.)
*
2.3 Order of precedence. In the event of a conflict between the text
of this document and the references cited herein (except for related associated
detail specifications, specification sheets, or MS standards),the text of this
document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
REQUIREMENTS
3.
3.1 Qualification. The mask assemblies furnished under this
specification shall be products which are authorized by the qualifying activity
for listing on the applicable Qualified products List at the time of award of
contract (see 4.3 and 6.3). In addition, the retention of the qualification for
the mask assembles on the applicable qualified products list shall be dependent
on periodic verification of continued compliance with the requirements of this
specification (see 4.3 and 4.3.2).
*
3.2 First article. When specified (see 5.2f), a sample shall be
subjected to first article inspection (see 6.4) in accordance with 4.4.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business