MIL-R-85523A(AS)
PUBLICATIONS
OFFICE OF THE ASSISTANT SECRETARY OF DEFENSE FOR ACQUISITION AND LOGISTICS
List)
SD-6 - Provisions Governing Qualification (Qualified Products
(Copies of specifications, standards, handbooks, and drawings required by manufacturers in connection with specific acquisition functions should be obtained from the contracting activity or as directed by the contracting officer.)
2.2 Non-Government publications. The following document(s) form a part of this specification to the extent specified herein. Unless otherwise specified, the issues of the documents which are DoD adopted are those listed in the issue of the DODISS cited in the solicitation. Unless otherwise specified, the issues of documents not listed in the DODISS are the issues of the documents cited in the solicitation (see 6.2b).
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM D1149 - Rubber Deterioration-Surface Ozone Cracking in a Chamber
(Flat Specimen)
Application for copies should be addressed to the American Society for Testing and Materials, 1916 Race Street, Philadelphia, PA 19103.
(Non-Government standards and other publications are normally available from organizations that prepare or distribute the documents. These documents may also be available through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this specification and the references cited herein, the text of this document shall take precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Qualification. The regulators furnished under this specification shall be products which are authorized by the qualifying activity for listing on the applicable qualified products list at the time of award of contract (see 4.3 and
6.4).
3.2 First article. When specified (see 6.2), the regulator shall be subjected to first article inspection (see 6.5) in accordance with 4.4.
3.3 Selection of specifications and standards. Specifications and standards for necessary commodities and services not specified herein or in applicable detail specifications, shall be selected in accordance with
MIL-STD-970.
3.4 Parts, materials and processes. In the selection of parts, materials and processes, fulfillment of major design objectives shall be the prime consideration. Materials shall conform to referenced specifications and shall be as specified herein and on referenced drawings. Materials which are not covered by specifications, or which are not specifically described herein, shall be of
the best quality, of the lightest practicable weight, and suitable for the purpose intended.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business